Unit Had a Door That Had Fallen Off
Unit had a door that had fallen off. I bent the bottom hinge back in shape and reinstalled the door. Unit turned on and cooled fine on 2/23/24 in Arlington Texas. Near Valcasi Dr Arlington, Texas 76001 Check out the Areas We Serve and jobs we are doing by clicking https://dallas.arlington.prorefrigerationone.com/areas-we-serve/ [spacer]
Disconnect Power and Cut Insulation and Piping at Both Ends
Disconnect power and cut insulation and piping at both ends. Using existing pipe along with necessary new pipe reroute through roof and out of the concrete wall using PVC sleeve above the outdoor walk in. Pull vacuum on both systems, seal the holes in the concrete with foam and fire-retardant sealant. Restore power and open […]
Joint Leaking by the Evaporator
Joint leaking by the evaporator. Rewelded joint and checked, No leaks at this time, and found no further problems at this time on 2/13/24 in Fort Worth Texas. Near N Fwy Fort Worth, Texas 76177 Check out the Areas We Serve and jobs we are doing by clicking https://dallas.arlington.prorefrigerationone.com/areas-we-serve/ [spacer]
Removed the Receiver Tank and Installed New One
Removed the receiver tank and installed new one. Replaced the filter drier. Checked again for leaks and found none. Verified proper operation and Temp on 2/7/24 in Arlington Texas. Near W Pioneer Pkwy Arlington, Texas 76013 Check out the Areas We Serve and jobs we are doing by clicking https://dallas.arlington.prorefrigerationone.com/areas-we-serve/ [spacer]
Encapsulated Low Pressure Control was Bad
Encapsulated low pressure control was bad. Picked up new pressure control and to installed. verified proper operation on 2/6/24 in Arlington Texas. Near E Lamar Blvd Arlington, Texas 76006 Check out the Areas We Serve and jobs we are doing by clicking https://dallas.arlington.prorefrigerationone.com/areas-we-serve/ [spacer]
Unit Had No Freon
Unit had no Freon. Added nitrogen and started to leak check. Found three leaks on condensing unit. Welded all three and pulled a good vacuum and made sure it held. Added 20 pounds of 404a and also replaced filter drier. Verified temp drop and proper operation on 2/5/24 in Arlington Texas. Near W Pioneer Pkwy […]